To connect a remote to your DIRECTV receiver, follow these steps:
1. Turn on the DIRECTV Receiver and TV:
Ensure both your DIRECTV receiver and TV are powered on.
2. Prepare the Remote:
Make sure your DIRECTV remote is working by inserting fresh batteries if needed.
3. Enter the Remote Pairing Mode:
– Press and hold the “Menu” button on the DIRECTV remote for about 5 seconds.
– The green light at the top of the remote will blink twice, then stay on.
4. Enter the Pairing Code (if prompted):
If you’re pairing the remote to a new receiver, the system might prompt you for a pairing code. If this is the case:
– Use the on-screen instructions to find the correct pairing code.
– Enter the code using the remote.
5. Automatic Pairing:
If you’re using a newer DIRECTV remote (such as the RC73 or RC78 model), the remote should automatically pair with the receiver once it is in pairing mode.
6. Test the Remote:
Try using the remote to control the DIRECTV receiver (e.g., change channels or open the menu). If it works, the remote is successfully paired.
If the remote doesn’t pair successfully, try the following:
– Reset the receiver by unplugging it for about 15 seconds and plugging it back in.
– Repeat the pairing process after the receiver restarts.
You can also manually sync the remote by entering the setup mode:
1. Press and hold the “Select” and “Mute” buttons simultaneously until the green light at the top of the remote blinks twice and stays on.
2. Enter the 5-digit code for your receiver (you can find these codes online or in the DIRECTV manual).
3. After entering the code, press “Select” to confirm.
If these steps don’t work, check for issues with the remote or receiver, or contact DIRECTV customer support.
