How to Install a Wright Door Closer- A Step-by-Step Guide for a Smooth Installation

How to Install a Wright Door Closer

Installing a Wright door closer is a straightforward process that can enhance the functionality and safety of your door. Whether you’re replacing an old door closer or installing one for the first time, following these step-by-step instructions will ensure a successful installation.

Step 1: Gather the Necessary Tools and Materials

Before you begin, gather the following tools and materials:
– Wright door closer
– Drill and drill bits
– Screwdriver
– Level
– Tape measure
– Adjustable wrench
– Lockset or latch (if needed)
– Mounting hardware (screws, bolts, and nuts)

Step 2: Remove the Existing Door Closer (if applicable)

If you’re replacing an existing door closer, start by removing it. First, disconnect the power supply if the door closer is electrical. Then, remove the mounting hardware using the appropriate tools. Be sure to keep track of the hardware for reuse.

Step 3: Locate the Door Closer Mounting Plate

Position the mounting plate on the door frame where the door closer will be installed. Use a level to ensure the plate is perfectly horizontal. If the plate has pre-drilled holes, align them with the door frame’s stud. If not, mark the location for the screws.

Step 4: Secure the Mounting Plate to the Door Frame

Using the appropriate screws, secure the mounting plate to the door frame. Make sure the plate is tight and level. If the plate has a strike plate, attach it to the door frame as well.

Step 5: Install the Door Closer

Position the door closer on the mounting plate, aligning the holes in the door closer with those in the mounting plate. Insert the screws and tighten them using the screwdriver. Be sure to check the door closer’s alignment and adjust if necessary.

Step 6: Attach the Door Closer Arm

Attach the door closer arm to the door closer using the provided bolts and nuts. Tighten the bolts with the adjustable wrench until the arm is securely attached.

Step 7: Adjust the Door Closer

Adjust the door closer to achieve the desired door closing speed and hold-open angle. Refer to the door closer’s manual for specific instructions on how to make these adjustments. Use the level to ensure the door closer is level and properly aligned.

Step 8: Test the Door Closer

Open and close the door several times to ensure the door closer is functioning correctly. The door should close smoothly and securely. If the door doesn’t close properly, revisit the adjustment steps and make any necessary changes.

Conclusion

Installing a Wright door closer is a relatively simple task that can greatly improve the functionality and safety of your door. By following these step-by-step instructions, you can ensure a successful installation and enjoy the benefits of a properly functioning door closer.