Step-by-Step Guide- How to Install a Water Filter in Your Frigidaire Refrigerator

How to Install Water Filter in Frigidaire Refrigerator

Installing a water filter in your Frigidaire refrigerator is a simple process that can greatly improve the taste and quality of your drinking water. By following these step-by-step instructions, you can ensure that your refrigerator is equipped with a reliable and efficient water filter in no time.

Step 1: Purchase the Right Water Filter

Before you begin the installation process, it’s important to purchase the correct water filter for your Frigidaire refrigerator. The most common water filters for Frigidaire models are the Frigidaire FF100A, FF100B, FF100C, and FF100P. Make sure to check your refrigerator’s model number to ensure compatibility.

Step 2: Turn Off the Water Supply

To prevent any accidental water leaks, turn off the water supply to your refrigerator. This can typically be done by turning the valve located behind the refrigerator. If you’re unsure of the location of the valve, consult your refrigerator’s manual for guidance.

Step 3: Remove the Old Water Filter

Locate the water filter housing on the back of your refrigerator. Gently pull the housing out to access the old water filter. You may need to twist the housing slightly to release it. Once the housing is open, pull the old filter out and discard it.

Step 4: Install the New Water Filter

Take the new water filter and insert it into the housing. Make sure that the filter is oriented correctly and securely in place. Push the housing back into the refrigerator until it clicks into place.

Step 5: Turn On the Water Supply

Now that the new water filter is installed, turn the water supply valve back on. This will allow water to flow through the new filter and begin the filtration process.

Step 6: Flush the Filter

It’s important to flush the new water filter for the first few gallons of water to remove any sediment or particles that may have accumulated during shipping. Run the water from the refrigerator’s dispenser for about 3-5 minutes or until the water runs clear.

Step 7: Reset the Filter Indicator

Frigidaire refrigerators typically have a filter indicator light that lets you know when it’s time to replace the filter. To reset the indicator, locate the reset button on the refrigerator’s control panel. Press and hold the button for a few seconds until the light turns off.

Congratulations! You have successfully installed a water filter in your Frigidaire refrigerator. By following these steps, you can enjoy clean, refreshing water from your refrigerator’s dispenser for months to come.